2 – CS 300 RM Gate Controls / Rev. B 1.0
1. Contents
3. General safety instructions
2. Key to symbols
Original operating instructions
−
Protected by copyright.
−
No part of this manual may be reproduced without our
prior approval.
−
Subject to alterations in the interest of technical progress.
−
All dimensions are given in millimetres.
−
The diagrams in this manual are not to scale.
Guarantee
The function and safety of the equipment is only guaranteed
if the warning and safety instructions included in these opera-
ting instructions are adhered to.
MFZ Antriebe GmbH + Co. KG is not liable for personal injury
or damage to property if these occur as a result of the war-
nings and safety advice being disregarded.
Using the equipment for its intended purpose
The CS 300 RM control unit is intended exclusively for the
purpose of controlling tubular drives that have mechanical
limit switch systems.
Target group
Only qualified and properly trained electricians are allowed to
connect up, programme or service the control unit.
Qualified and trained electricians must have the following:
− Knowledge of the general and specific safety and accident-
prevention regulations
−
Knowledge of the relevant electrical regulations
−
Training in the use and care of appropriate safety equip-
ment
−
The ability to recognise the risks associated with electricity
Instructions relating to installation and connection
−
Before commencing electrical works, the system must be
disconnected from the power supply. Measures must be
taken to ensure that the power supply remains switched off
for the duration of the works.
−
The local safety regulations must be observed.
−
Power cables must be laid separately from control cables.
Danger of personal injury!
The safety instructions must be observed!
Warning! Danger to property!
The safety instructions must be observed!
Information
Special information
OR
Reference to other sources of information
1.
Contents
2
2.
Key to symbols
2
3.
General safety instructions
2
4.
Overview of products
3
5.
Initial operation
5
6.
Programming with the LED module
10
7.
Programming with the LCD monitor
12
8.
Navigator (LCD monitor only)
14
9.
Overview of functions
16
10.
Error messages and rectification
23
11.
Technical data
24
12.
EC Declaration of Incorporation
25
13.
Appendix
26
