Fig. 6
DEFLATING THE BOUNCER
CONNECTING THE SLIDE
To deflate the bouncer:
13. Open the large air outlet near the control panel. (Fig. 6)
14. Turn the knob on the control panel to DEFLATE.
15. Once deflated, turn the knob on the control panel to OFF, unplug the unit and store the cord inside the
control panel door. (Fig. 7)
Once the slide is inflated it must be buckled to the bouncer. To do so:
11. Flip the slide over and position it onto the bouncer.
12. Once positioned, lift slide slightly on one side and connect four
buckles as shown (Fig. 5A) then repeat for the other side.
Fig. 7
MAINTENANCE
2
3
3. With the knob on the control panel in the OFF position, open the cord storage area door and carefully extend
the cord. (Fig. 1)
4. Plug the cord into the wall outlet.
5. Turn the knob on the control panel to INFLATE. (Fig. 1)
6. Allow the Bouncer to inflate until it is firm but the seams still show slight wrinkling then turn the knob to OFF.
(DO NOT over-inflate.)
NOTE: The knob must be completely centered at OFF to prevent deflation. (Fig. 1A)
7. Place the power cord in the control panel cord storage door prior to allowing children to play on the unit.
In the event the bouncer is accidentally punctured, an adult must perform the following steps:
1. Deflate the item, clean the punctured area with water and allow it to dry.
2. Cut a portion of the patch allowing approximately 1
1
/
2
inches of excess patch material on all sides of the opening to be
patched and round the corners.
3. Remove the backing from the patch material, position the patch over the damaged area and smooth out any bubbles with a
paper towel.
4. Allow the item to sit for 30 minutes before re-inflating.
The product should be periodically examined for potentially unsafe conditions such as: damaged cord, plug, housing, etc.
In the event such damage is found, the product should not be used until properly repaired. Refer to the instructions for set-up,
storage, maintenance and care. To clean use mild detergent and water.
REPAIRING A PUNCTURE
INFLATING THE BOUNCER
INFLATING THE SLIDE AND TEETH
A small pressure release
opening (Fig. 2A) is
incorporated behind the
dinosaur’s head (Fig. 2).
This opening is not connected
to the main inflation chamber
and poses no risk of deflation.
Do not use the included repair
patches to cover this opening,
as it is important for
maintaining balance in the
dinosaur head.
Fig. 2
Fig. 2A
Fig. 1
OPEN
FOR
CORD
STORAGE
Fig. 1A
8. Open the inflating plug cap in the airway as shown (Fig. 3A).
9. Blow up slide by mouth or use hand or foot pump (Fig. 3).
10. Once inflated replace the plug cap immediately and press firmly.
NOTE: To deflate the slide or teeth, remove the plug cap and insert
the deflater into the airway to hold it open. Then press down
on the slide until all air has been expelled.
Fig. 3
Fig. 3A
Fig. 4
Fig. 4A
REPEAT STEPS FOR INFLATING THE TEETH.
Fig. 5
Fig. 5A
BUCKLES
