MGE UPS SYSTEMS
Pulsar ES 5+: E-51032513XT/AC
25
overload
utility power present
operating anomalies
device fault
battery fault
1a flashing
1e on
1 beep every second
Pulsar switches off automatically after
operating in overload for approximately
5 min.
no utility power present
1a flashing
1e flashing
1 beep every second
Pulsar switches off automatically after a
length of time which depends on the level
of overload.
NB:
Overload occurs if the power consumption of
the connected applications is greater than
the rated power of Pulsar. To acknowledge
the fault, release button 3 , temporarily
disconnect Pulsar from the wall outlet
(flex 5 ), disconnect non-critical
applications and re-start Pulsar.
1b flashing
1e on
1 beep every second
v
vv
v
v
switch off Pulsar (release button 3 ),
disconnect from the wall socket (flex 5 ),
and check that Pulsar has not short-circuited
(disconnect all applications),
v
vv
v
v
check the input fuse 6b and replace it with
a fuse of the same rating,
v
vv
v
v
re-start Pulsar.
A battery test is carried out while Pulsar,
is in start-up phase, then automatically
every 7 days. If a battery fault is
detected, the following occurs:
recharge your battery for 8 hours.
1c flashing
1e on
1 beep every second
utility power out of tolerance
…
1a to 1e off
continuous beep
after the start-up sequence, if the audio
warning device sounds continuously, check
the voltage and frequency of your
utility
power
(see the § entitled "characteristics")
and/or recharge your battery for 8 hours.
NB:
If the previous symptoms persist, contact our
after sales service.
