5103321100/AA
- Page 19
The protected equipment connected to the UPS can be energized, whether AC input power is available
or not.
Prior to initial start-up, check the UPS voltage settings. If the protected equipment voltage is other
than 230 V / 50 Hz, the UPS settings must be modified using the "UPS Driver" software
(see section 3.5).
1. Set the battery circuit breaker(s) to ON.
2. Press the ON / OFF button .
All connected equipment is energized. The buzzer sounds.
LEDs , and go ON.
If LEDs , and do not go ON or if LEDs , , or flash, there is a fault (see section 4.1).
3.3 Bargraph indications
LEDs to provide three different indications.
1. Remaining backup time in percent.
2. Percent load drawn by the protected equipment,
when button is pressed.
3. Operating faults (flashing LED and beeps):
Overload.
UPS fault.
Battery fault.
Excessive ambient temperature.
3. Operation
3.2 Start-up
21
22
23
24
18
14
17
21 22
23
14
15
16
17
14
15
16
17
18
8
24
27
8
14
15
16
17
