MGF Silent compressors operating
instruction manual
7
OPERATION
1. Before switching on the compressor - 17 Lt. And 30 Lt. Pumps versions only: remove
the black rubber cap placed at the top of the aspiration pipe (Fig. 1.A ) and replace it
with the aspiration filter (Fig. 1.B ) supplied together with your Silent compressor.
Fig. 1. A Fig. 1. B
2. Before switching on the compressor - 50 Lt. Pumps versions only: remove the plastic
tap placed in the hole of the aluminum cap (Fig. 2.A ) and replace it with the
aspiration filter (Fig. 2. B ) supplied together with your Silent compressor.
Fig. 2. A Fig. 2. B
ATTENTION:
without black cap removal or plastic tap removal the compressor will not be able to
work and you may seriously damage it.
3. Make sure that the compressor is level at all times. Do not operate the compressor if
it is at an incline as this will result in pump failure due to loss of circulation.
4. Check that you have adequate power supply and that the mains voltage corresponds
with that shown on the data label on the back side of the compressor.
