2
Brief introduction for the Remote Transmitter
Mode Button: hold over 3 seconds to turn on/off the Remote Transmitter.
Press the button to choose the different modes. There are 5 modes as follows:
V S
1
2
R T
Vibration mode
Static mode
1-9 Intensity Level
Run mode
1-9 Different Tones
OR
Location mode
Channel 1 or 2
Tone mode
Low Battery
Indicator
V
is the Vibration mode for the Training Collar
S
is the Static mode for the Training Collar
8
is the intensity Level of Vibration or Static
R
is the running mode for the Remote Beeper and also re-activates the Remote Beeper functions
after being disabled by the Location mode.
T
is the Tone Mode and allows you to choose from 9 different Remote Beeper Sound options
L
is the Location Mode and also disables the Remote Beeper Functions
3
is showing the third option from the different tone sounds
Channel button
: Choose the different channels for Training Collar or/and beeper collar
Transmitter button
: confirm the operation and send the signal to the collars
Up/Down button
: adjust intensity levels of stimulation and choose the different tone sounds
Charging Jack
: connect to the charger
Brief introduction for the Waterproof Training Collar
:
Corrects the dog behaviour by stimulations (vibration or shock).
On/Off button
: Turns the Training Collar on/off. Also set to be ready to encode the transmitter and
Training Collar by holding the on/off button for 10 seconds
Receiver indicator Light:
Indicates when turned on/off and also serves as low-battery indicator
and after charge full.
Antenna
Charging Jack
Indicator Light
Channel (Collar) selector
Up/Down Button
Transmitter Button
Mode Button
