Loading c
onsumables
31
¾
Tap
, and a confirmation message appears. Select
Yes
to
pause the wash. Tap
again to resume the wash.
¾
Tap
, and a confirmation message appears. Select
Yes
to
stop the wash.
5. When the wash is complete, take out all the consumables by
following the on-screen instructions.
6. Tap
Back
to return to the main interface A.
7. Store the washing flow cell at the room temperature.
Each washing flow cell can be reused up to three times for
washing. Then, dispose of the flow cell according to local
regulations and safety standards of your laboratory.
8. Empty any remaining washing solution in the washing plate into
an appropriate waste container. Dispose of the waste according to
local regulations and safety standards of your laboratory.
We recommend that you dispose of the washing plate after three
months of continuous use.
Loading consumables
DNB ID
Post-loading plate ID
Flow cell ID
Load post-loading plate
Load DNB tube
Load flow cell
Back
Start
A: Preparing
x.xx kPa
x.xx
°
C
REF+SN, e.g. 1000000000S0000000000
A
B
Figure 10 Loading consumables interface
Perform the following steps:
1. Open the loading compartment door.
2. Place the label of the plate near the RFID scanning area. The plate
ID is displayed in the box.
Summary of Contents for MGIDL-T7RS
