MGI Zip Navigator AT, User Manual

3.3 Rear Wheels Positions

The MGI Zip Navigator AT is designed to allow the rear wheels 
to be in two positions. The position is determined by where the 
wheel is locked on the axle in either of the two grooves [see 
picture]. The drive position is used during the normal operation of 
the Zip Navigator AT. The free wheel position is used to freely push 
the Zip Navigator AT should you experience battery or  
Zip Navigator AT issues on the course.

i. Drive position

– Lock the wheel onto the groove closest to the 

battery base. To do this, press the grey release button on the 
wheel hub, push the wheel on to the axle as far as possible. To 
test for drive position try rolling the wheel backwards. If you feel 
resistance then the wheel is now in drive position and ready to 
use. Repeat for both wheels.

ii. Free wheel

 – 

Lock the wheel into the groove closest to the end 

of the axle. To do this, press the grey release button on the wheel 
hub, push the wheel on to the axle and push the release button 
onto the groove. To test for free wheel position try rolling the 
wheel backwards. The wheel should spin freely with no resistance. 
Repeat for both wheels.

3.4 Unfolding

Please see below  
the steps to unfold  
a Zip Navigator AT Handle.

Step 7:

 Push the top bag support down to move it into position.

06

Free wheel position

Drive position

Step 1:

 Ensure both rear 

wheels are attached.

Step 2:

 Release fold lever.

Step 4:

  The handle is now free to pull 

upwards. The handle will naturally 
unfold as you continue to pull until the 
handle is completely open.

Step 3:

 Move the top 

bag support away from 
front wheel assembly until 
you hear it click.

MGI Zip Navigator All Terrain 

User Manual

07

Step 6:

 Close the fold lever to lock 

the handle into place in one  
of three positions. 

Step 5:

 Ensure that  

the latch at the bottom 
of the handle clicks into 
place.