RYZ
Remove the bottom securing bolt (3) on the rear silencer.
Unscrew the top securing bolt (4) on the rear silencer.
Separate the silencer from the exhaust pipe.
Remove the exhaust pipe.
CARBURETTOR
REMOVAL
Remove the seat – see “Removing the seat” in this section.
Remove the fuel tank – see “Removing the fuel tank” in this
section.
Disconnect the carburettor heating pipes (1).
Remove the throttle cable (2).
Remove the bolt from the starter motor connector (3).
Remove the oil pipe (1).
Loosen the clamp on the inlet connection (5) with a 3 mm male
safety spanner.
Special tool – 3 mm safety spanner
Ref. 25 0020001 8
Loosen the clamp on the air fi lter connection (6).
Free the carburettor from the inlet connection.
Remove the carburettor.
4)
5)
6)
7)
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
4-12 CHASSIS
CAUTION:
Plug the pipes to prevent coolant from spilling.
4
Summary of Contents for RYZ 50 Cross C
