Mi-T-M
CW-GASOLINE / DIESEL Operator's Manual
3
installation & preparation
pre-start inspection procedures:
Before starting the unit, perform the following procedures:
. Check the oil level in the pump and engine.
. Inspect the water inlet strainer. Clean or replace if necessary. See
"Water Supply," #2, pg. 12.
3. Check all hose connections to ensure they are securely tightened. See
"Water Supply," #3, pg. 12.
4. Inspect for system water leaks, oil leaks and fuel leaks. If a fuel leak is
found, DO NOT START UNIT! See "Risk of Explosion or Fire" warnings,
pg. 4. Be sure that all damaged parts are replaced and that the mechanical
problems are corrected prior to operation of the unit. If you require
service, contact Mi-T-M Customer Service.
5. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
is found, DO NOT USE HOSE! Replace hose before starting unit. See
"Risk of Injection" warnings, pg. 5. Be sure that all damaged parts are
replaced and that the mechanical problems are corrected prior to operation
of the unit. If you require service, contact Mi-T-M Customer Service.
end of preparation instructions
warning
tHe following pages contain operating and
maintenance instructions
do not attempt to operate tHis pressure wasHer
until you HaVe read and understood all safety
precautions and instructions listed in tHis manual.
incorrect operation of tHis unit can cause serious
inJury!!
do not alter or modify tHis eQuipment in any manner!
Summary of Contents for CW-GASOLINE
Page 21: ...Manual del Operador 21 NOTES ...
