CWC-GASOLINE / DIESEL Operator's Manual
installation & PreParation
WARNING
risK of inJection causinG
seVere inJurY!
neVer looK directlY at
tHe noZZle unless it is dis-
connected froM tHe Gun/
lance asseMblY!
noZZle reVieW:
Various nozzles may be quick-connected into the end of the lance to change
the spray pattern or use the detergent feature. When using quick connects
(Q.C.), be certain the connection is securely locked. If not, the high pressure
water may shoot the nozzle from the lance, causing severe injury or serious
damage. To determine spray fan, refer to the actual number stamped on
the nozzle. The first two digits indicate the spray fan in degrees, i.e.: 00=0°,
15=15°, 25=25°, 40=40°, 65=detergent/low pressure.
.
the 0° nozzle (red)
: This is a blasting nozzle. It delivers a very concentrated
stream of water. Be cautious when using the straight narrow stream. It is
not recommended for use on painted or wood surfaces or items attached
with adhesive backings. Uses: Removing weeds from sidewalk cracks,
stubborn stains from concrete, masonry, aluminum and steel, caked mud
from equipment, and cleaning lawn mower undersides.
2.
the 15° nozzle (YelloW)
: This is a chiseling nozzle. The spray
should be directed at a 45° angle to the surface and used like a scraper
to remove paint, grease and dirt. Uses: Surface preparation (removing
mildew stains and paint chips), cleaning gutters and downspouts.
3.
the 25° nozzle (Green)
: This is a flushing nozzle. This pattern is best
suited for flushing dirt, mud, and grime. Uses: Wet sweeping leaves from
walks, curbs and driveways, cleaning stable floors, washing swimming
pool bottoms, degreasing engines.
4.
the 40° nozzle (WHite)
: This is a wash nozzle. This wide spray pattern
disperses the water pressure over a large area and is recommended for
moderate washing. Uses: Washing down aluminum siding, cleaning
windows, washing vehicles, spraying sidewalks, driveways and patios.
5.
the 65° nozzle (blacK)
: This is a low pressure detergent application
nozzle. This broad spray pattern distributes solution over vast areas
under low pressure. Uses: Detergent application, misting or rinsing.
QuicK-connect (Q.c.) noZZles
connection of Q.c. noZZles
WARNING
risK of seVere inJurY!
tHe triGGer Gun sHould
alWaYs be locKed in tHe off
Position WHen not in use!
noZZle connection:
. Ensure the trigger gun is locked in the
off
position. See
WARNING
,
right.
2. The quick-connect nozzle should be disconnected from the gun assembly
at this time. As shown in the drawing below, retract the locking ring on
the quick-connect fitting to remove the nozzle.
