CWC-GASOLINE / DIESEL Operator's Manual
3
installation & PreParation
Pre-start insPection Procedures:
Before starting the unit, perform the following procedures:
. Check the oil level in the pump and engine.
2. Inspect the water inlet strainer. Clean or replace if necessary. See "Water
Supply," #2, pg. 2.
3. Check all hose connections to ensure they are securely tightened.
4. Inspect for system water leaks, oil leaks and fuel leaks. If a fuel leak is
found, DO NOT START UNIT! See "Risk of Explosion or Fire" warnings,
pg. 4. Be sure that all damaged parts are replaced and that the mechanical
problems are corrected prior to operation of the unit. If you require service,
contact your Customer Service.
5. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak is
found, DO NOT USE HOSE! Replace hose before starting unit. See "Risk
of Injection" warnings, pg. 5. Be sure that all damaged parts are replaced
and that the mechanical problems are corrected prior to operation of the
unit. If you require service, contact your Customer Service.
end of PreParation instructions
WarninG
tHe folloWinG PaGes contain oPeratinG
and Maintenance instructions.
do not atteMPt to oPerate tHis Pressure
WasHer until You HaVe read and
understood all safetY Precautions
and instructions listed in tHis Manual.
incorrect oPeration of tHis unit can
cause serious inJurY!!
do not alter or ModifY tHis eQuiPMent
in anY Manner!
