CONTROLS
Operator’s Manual
15
NEVER INTERFERE WITH THE OPERATION OF THE
CIRCUIT BREAKER KNOB OR KEEP PUSHING IT
IN THE “ON” POSITION.
USB RECEPTACLES:
The generator comes equipped with a double USB recep-
tacle. The top is a 5V 1A USB port and the bottom is a 5V
2.1A USB port.
LOW OIL LEVEL SHUTDOWN:
The generator is equipped with a low oil level shutdown
that is designed to protect the engine from damage
caused by an insufficient amount of oil in the crankcase.
When the oil level in the crankcase falls below the safe
operating limit, the low oil level light will illuminate and the
engine will automatically shutdown.
CO DETECTOR (SHUT OFF SYSTEM)
The (carbon monoxide) CO Detector monitors the accu-
mulation of CO gas while the generator is running and will
shut off the engine if the levels become dangerously high.
The CO Detector on this generator is not a substitute for
an indoor CO alarm.
Whenever the CO Detector has shut off the engine there
will be a light on the control panel that indicates the rea-
son. Read the CO Action Label for the next steps to take.
If the CO Detector light is flashing “red” you must leave
the area immediately and relocate to an open outdoor
area. Ventilate the area thoroughly before occupying again.
Ensure the generator is located in an open outdoor area
with the exhaust pointed away from occupied structures.
If anyone experiences dizziness, headaches, nausea, or
tiredness get to fresh air immediately and seek medical
attention.
If the CO Detector light is a constant “yellow” then a
system fault has occurred, or it is indicating that it has
reached the end of its life. This fault can only be diagnosed
and repaired by an Authorized Service Provider.
The CO Detector monitors the accumulation of CO gas
from all sources in the area around the generator. If the
CO Detector light is flashing “red” this is not an error and
safety measures must be taken immediately.
Note: Tampering with the CO Detector could result in
hazardous conditions and must be avoided.
Note: The generator must not be operated in ambient
temperatures greater than 131°F (55°C) as this can
damage the CO Detector.
Summary of Contents for GEN-2000-iMM1
Page 91: ...Manual del Operador 91 ...