28
Operator’s Manual
mAInTenAnCe
CLEANING AND GAPPING SPARK PLUG:
If the plug is contaminated with carbon, remove it using a
plug cleaner or wire brush.
Check the spark plug gap and reset it if necessary. The spark
plug gaps are listed below. To change the gap, bend the side-
electrode only, using a spark plug tool. (Fig. 9)
Install and tighten the spark plug. Connect the spark plug
lead.
Recommended Spark Plug:
SPARK ARRESTOR:
If the generator has been running, the muffler will be very
hot. Allow it to cool before proceeding.
NOTE:
Remove and clean spark arrester every 100 hours
or as necessary.
NOTE:
Product users on United States forest service land, and
in some states, must comply with fire
prevention regulations.
Clean the spark arrester as follows: (Fig. 0 and )
1. Loosen the screw by the exhaust port of the muffler and
remove the spark arrester.
2. Use a brush to remove carbon deposits from the spark
arrester screen. Inspect the screen for breaks or tears and
replace it if necessary.
3. Install the spark arrester in the reverse order of removal.
Spark arrestors are available from your local Mi-T-M Customer
Service. Other user requirements may apply, check with your
Federal, State or local authorities.
Service
Spark Plug Gap
(See recommendations)
SPARK ARRESTER SCREEN
SPARK ASSESTER
SCREW
(Fig. 9)
(Fig. )
(Fig. 0)
Engine
Subaru
Honda
Spark Plug
NGK BR-6HS
NGK BPR6ES
Spark Plug Gap
0.6 - 0.7 mm
(0.02-0.03 in.)
0.7 - 0.8 mm
(0.03 in.)
Torque - New
8.7-0.9 ft-lb
Torque - Retighten
6.6-9.5 ft-lb
Summary of Contents for GEN-2500-0MS0
Page 4: ... Operator s Manual Contents ...
Page 38: ...38 Guide d utilisation Table de matières ...
Page 72: ...72 Manual del Operador Materias ...
Page 102: ...102 Manual del Operador Nota ...
