CONTROLS
16
Operator’s Manual
Note: The generator must not be operated in ambient temperatures
greater than 131°F (55°C) as this can damage the CO Detector.
FUEL TANK
The fuel tank has a capacity of 5.3 gallons (20.20L).
GROUND TERMINAL
The ground terminal is used to assist in properly grounding the genera-
tor to help protect against electrical shock. Consult with a qualified local
electrician for grounding requirements in your area.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of lubricant in
the crankcase is insufficient. The engine may not be restarted until suffi
-
cient engine lubricant has been added to the generator.
LOW OIL, OUTPUT AND OVERLOAD LAMP:
This generator is equipped with 3 Display LEDs that indicate Low Oil,
Overload, and Output Power. The low oil indicator will illuminate red
when there is an insufficient amount of oil in the crankcase. The overload
indicator will illuminate red when there is a short circuit in a connected
load, or the generator is overloaded. The output power indicator will
illuminate green when the generator is in normal operation.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the generator when
necessary.
OIL DRAIN PLUG
When changing the engine lubricant, unscrew and remove the oil drain
plug to allow old engine lubricant to be drained.
RESET BUTTON
The reset button is used to restore power if an overloadoccurs. To
restore power, remove the last electrical load added, then depress the
reset button.
RECOIL STARTER
The starter grip and rope is used (along with the engine switch) to start
the generator’s engine.
USB RECEPTACLES:
The generator comes equipped with a double USB receptacle. The top
is a 5V 1A USB port and the bottom is a 5V 2.1A USB port.
WARNING: DO NOT PUT FOREIGN OBJECTS INTO THE PLUG
RECEPTACLE.
CAUTION: DO NOT PLUG MORE THAN TWO APPLIANCES INTO
THE GENERATOR AT A TIME.
CAUTION: IF CIRCUIT BREAKER CONTINUES TO TRIP,
CHECK APPLIANCE FOR DEFECT. IF GENERATOR IS
MALFUNCTIONING, SEE YOUR AUTHORIZED MI-T-M
SERVICE CENTER.
NEVER INTERFERE WITH THE OPERATION OF THE CIRCUIT
BREAKER KNOB OR KEEP PUSHING IT IN THE “ON”
POSITION.
