Long Life Vertical LV-Series Operator’s Manual
11
INSTALLATION & PREPARATION
NOZZLE REVIEW:
1.
Your pressure washer will come with one of the following types of nozzle
assemblies: Adjustable, Quick-Connect or High/Low. Review the nozzle
assembly instructions listed below or on the following page which pertain to
your unit. NOTE: Nozzle assembly should NOT be connected to the gun
assembly at this time.
A. ADJUSTABLE NOZZLE: The Adjustable Spray Pattern Nozzle
(with lance) has two functions:
1.
Selections of high and low pressure can be achieved by
pulling the nozzle cover at the end of the wand
"TOWARD" yourself for the High Pressure setting, and
pushing the nozzle cover "AWAY" from yourself for Low
Pressure and detergent application.
2.
The spray pattern can be adjusted from 0° to 60° by
rotating the nozzle cover at the end of the wand in a
clockwise and counterclockwise direction. Be cautious
when using the straight narrow stream. It is not
recommended for use on painted or wood surfaces, or
items attached with adhesive backings
B. HIGH/LOW NOZZLE:
1.
Selection of high pressure can be achieved by turning the
protective collar to the right (clockwise) as shown in Figure 1 at
left. While in the high pressure mode, water is directed soley
through the 15° spray nozzle creating a concentrated high
pressure "fan" spray.
2.
Selection of low pressure detergent application can be achieved
by turning the collar to the left (counterclockwise) as shown in
Figure 2 at left. Once the pressure is low enough, the detergent
injector on the pressure washer will draw detergent into the
system. As the collar is turned, a water/detergent mixture exits
not only from the spray nozzle, but also around the nozzle. This
creates a "fan/cone" combination spray pattern.
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
NEVER LOOK DIRECTLY AT THE
NOZZLE ORIFICE UNLESS IT IS
DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
WHEN USING THE ADJUSTABLE OR
HIGH/LOW NOZZLE, NEVER ADJUST
THE SPRAY PATTERN WHILE THE
TRIGGER GUN IS OPEN!
ADJUSTABLE NOZZLE
OMGEN240/121296/JTR
OMGEN224/21696/DCE
HIGH/LOW NOZZLE
