16
Propane Patio Heater Manual
Screw gas hose and regulator onto propane 8 cylinder (not included). Do not cross-thread.Every part of the
heater should be secure against displacement and should be constructed to maintain a fixed relationship be
-
tween essential parts under normal and reasonable conditions of handling and usage. Parts not permanently
secured should be designed so they cannot be incorrectly assembled and cannot be improperly located or
misaligned in removing or replacing during cleaning or other servicing.
Not included.
Use a standard 20 lb. (Not included.)propane cylinder only (approximately 12.2 in./ 31 cm. in diameter and
17.9 in. / 45.5 cm high).
Use this heater only with a propane vapour withdrawal supply system. See the standard for storage and
handling of liquefied petroleum gas, ANS/NFPA 58. Your local library or fire department should have this
book. Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from
the appliance. A cylinder must be stored outdoors in a well ventilated area out of the reach of children. A
disconnected cylinder must have dust caps tightly installed and must not be stored in a building, garage or
any other enclosed area. The maximum inlet gas supply pressure: 250 psi /1750 kPa. The minimum inlet gas
supply pressure: 5 psi /35 kPa. Manifold pressure with regulator provided: 11 inch W.C/ 2.74 kPa. The pres-
sure regulator and hose assembly supplied with the appliance must be used. The installation must conform
with local codes, or in the absence of local codes, with National fuel gas code, ANSI Z223.1/NFPA54, Natu-
ral gas and propane installation code, CSA B149.1, or Propane storage and handling code, B149.2.
REPLACING GAS CYLINDER
Gas Hose
Regulator
Regulator
Gas Tank
Anchorning
