Work Pro WCW-Series Operator’s Manual
13
END OF PREPARATION INSTRUCTIONS
WARNING
THE FOLLOWING PAGES CONTAIN
OPERATING AND MAINTENANCE
INSTRUCTIONS
DO NOT ATTEMPT TO OPERATE THIS
PRESSURE WASHER
UNTIL YOU HAVE READ AND UNDERSTOOD
ALL SAFETY PRECAUTIONS AND
INSTRUCTIONS LISTED IN THIS MANUAL.
INCORRECT OPERATION OF THIS UNIT CAN
CAUSE SERIOUS INJURY!!
DO NOT ALTER OR MODIFY THIS
EQUIPMENT IN ANY MANNER!
PRE-START INSPECTION PROCEDURES:
Before starting the unit, perform the following procedures:
1.
Check the oil level in the pump (6) and engine (5).
2.
Inspect the water inlet strainer (9). Clean or replace if necessary. See
"Water Supply", #2, pg. 12.
3.
Check all hose connections to ensure they are securely tightened. See
"Water Supply", #5, pg. 12.
4.
Inspect for system fuel leaks. If a fuel leak is found, DO NOT START
UNIT! See "Fire & Ventilation Precautions", #2 and #4, pg. 4. Be sure
that all damaged parts are replaced and that the mechanical problems
are corrected prior to operation of the unit. If you require service, contact
Customer Service.
5.
Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
is found, DO NOT USE HOSE! Replace hose before starting unit. See
"Miscellaneous Safety Precautions" #6, pg. 6. Be sure that all damaged
parts are replaced and that the mechanical problems are corrected prior
to operation of the unit. If you require service, contact Customer Service.
INSTALLATION & PREPARATION
