Prodomus
26
the hair shorter set a shorter length of cut. Alternatively, use the same
setting and press a bit more firmly, while moving the appliance a bit
slower through the hair. This procedure requires practice and it is
always better to let the hair longer when cutting them for first time
Use the 10 or 20 mm hair length setting to cut the top hair on the head
quite short. Use the 4 or 7 mm setting for brush cut. Hold the length
attachment flat against the head, slowly start trimming from the front to
the back. Caution: Its recommended to leave the hair longer for the first
few haircuts..
CUTTING HAIR USING THE INTEGRATED THIN OUT FUNCTION
The thin out function allows you to thin out certain areas of hair with big
volume. You can use it with or without the length attachment.
When switching the ON/OFF switch into position upwards, the plastic
blade which partly covers the upper cutting blade is pushed out of the
appliance. This reduces the number of cutting teeth of the blade
considerably and less hair will be cut while using the thin out function.
When having removed the length attachment collect the strands of hair
that you want to cut with the comb. Then cut off the collected hair along
the comb with the adjusted thin out function.
OUTLINING:
You do not need the comb attachment for finishing the cut. Remove
the comb attachment from the appliance for this step.
Position clipper between the side burns and the ear.
Make sure the corner edge of the blade is against the hairline. With the
outline of the hair as your guide, slowly move the clipper over, around,
and behind the ear.
For the back of the neck and the sideburns, hold the clipper upside
down and holding it against the skin at the length desired, move
downwards.
