Prodomus
Manual
12
1. Heat up milk with frothing
function
(up to 160 ml max.):
•
In this case please fill up to lower
MAX mark only (approx. 160 ml),
cause milk gets more volume while
frothing.
•
Press the ON switch once only.
The LED control lamp will change to
blue colour. Milk will be heat up and
the beater unit is rotating inside the
kettle.
•
Frothing time is about 70-90
seconds. Then there will be an
automatic cut-off.
The control lamp
changes to red.
Caution! Unplug after
each use.
•
Pour milk foam into a cup.
If necessary use a spoon .
2. heat up milk
(up to 260
ml max):
•
In this case you can fill up to upper
MAX mark (approx. 260 ml). In this
case the round whisk at the beater
must be taken off the beater shaft.
Therefore press the small black
brackets together and pull off (see
fig. on page 13).
•
Close the lid firmly, till it is engaged.
•
Press the ON switch twice: The LED
control lamp will change to blue
colour. Milk will be heated.
The interval function of the beater
unit will rotate the milk and helps
to avoid sticking of milk in the kettle.
•
Heating time is about 70-90 sec.
Then there will be an automatic cut-
off. The control lamp changes to
red.
Caution! Unplug after
each use.
•
Pour hot milk into a cup.
If necessary use a spoon .
3. Froth cold milk
(up to160 ml max.):
•
In this case please fill up to lower
MAX mark only (approx. 160 ml),
cause milk gets more volume while
frothing.
•
Press the ON switch thrice.
The LED control lamp will change
to blue colour and will flash. The
beater unit is operating.
•
Frothing time is about 70-90
seconds. Then there will be an
automatic cut-off.
The control lamp changes to red.
Caution! Unplug after
each use.
•
Pour milk foam into a cup.
If necessary use a spoon .
C
C
l
l
e
e
a
a
n
n
i
i
n
n
g
g
a
a
n
n
d
d
c
c
a
a
r
r
e
e
CAUTION danger of damage
and electric shock! The base station
the kettle and the cord should never be
immersed into water or other liquid, to
avoid intrusion of water into the inner.
Act with special care while cleaning.
Ensure not to damage or bend the
beater shaft, while cleaning, to avoid
damage.
•
Immediately clean the appliance after
each use, to avoid germ develop-
ment and stick-drying of milk
residues.
•
Remove the milk kettle from its base
and empty completely.
•
The base station may not be
immersed into water or be cleaned
under running water. Just wipe it with
a damp cloth and let dry thoroughly.
