miAlert 2021 - www.miAlert.com
miPos2
Repeater
Installation and Operation Manual
1 Overview
The miPositon
BTLE
Repeater offers
advanced functionality
for
determining the location of a Pendant or Asset Tag withing a range
of 15 meters (45 feet) with a linear RSSI reading for determining
distance from Repeater. A Three Radio arrays - Bluetooth for
miPosition - LR 2.4Ghz for Emergency TX/RX - LoRa 915MHz for
Gateway Communications TX/RX. Also support up to 48 hours of
battery backup in the event of loss of main power.
Note:
For UL 2560 installations, refer to the
miPosition
Gateway
Installation Instructions
1.a miAlert Contact Information
If you have any problems with this procedure, contact miAlert technical
services:
• Email: support@mialert.com
• Toll Free: 855-382-8999
1.b Maximum Number of Repeaters for a UL 2560
Installation
To achieve the 99.99% alarm message reliability required for UL 2560
compliance, system installations must operate within the following limits for
end device and repeater counts.
1.c
Repeater
Components
Part #
Check-In
Location
Wearable
miPos2
Repeater
60 minutes
North America
Pendant & Tag
End Devices
Maximum
Repeaters
128
256
256
512
512
1028
1028
1028
2.
a Installation and Startup
a Installation Notes
• These products are designed to be maintained by certified
technicians.
• Products are intended for indoor use
, if installing them outdoors
they must be housed in a water resistant plastic enclosure.
• Repeater can be powered by 12-24VDC local or centralized power
supply, centralized power is recommended if installation requires
more than 48 of battery back-up.
•
Repeater is shipped
with
two 3.6VDC custom lithium AA
cell
not
installed.
Battery are for battery back-up use only.
• All products should be manually tested monthly. “Test the
Transmitter/Receiver section”.
www.mialert.com
Toll Free: 855-382-8999
Email: support@mialert.com
27 Armthorpe Rd, Brampton, L6T 5M4
A
B
C
Figure 1
A
Repeater Tamper Switch
B
LED status for Alarm condition and signaling
C
Installation configuration and Firmware update
button when cover is removed
D
Battery slots for housing two 3.6VDC batteries to
provide up to 48 Hrs of back-up
D
Figure 2
12-24VDC
POWER
TWO 3.6 VDC
CUSTOM
BATTERIES
