Press the power button to start the machine.
Open the Miaomiaoce APP, follow the prompts for data synchronization.
After the synchronization is completed, the thermometer can be used
normally. And the temperature measurement data before synchronization
will be automatically saved on the mobile device.
The thermometer can store 512 sets of body temperature data.
Press the power button to start the machine.
Open the Miaomiaoce APP, select "Alarm" in the options to set or close
the alarm wake-up time according to theprompts.
After the alarm is set, an alarm clock will appear on the thermometer
screen. The symbol will disappear when the alarm is cancelled.
When reaching the alarm wake-up time, the thermometer will emit a
continuous tone like bee-bee and turn on the backlight. Press the power
button shortly, then the alarm clock will be turned off.
If there is no operation for more than one minute, the alarm will
automatically turn off and enter the standby state. It is recommended to
manually turn off the alarm and extend the battery life.
After the alarm is manually turned off, the thermometer enters the
measure state automatically. Please put the thermometer into the mouth
and start measuring.
If the battery shows replacement indicator on the thermometer screen,
eg“ ”, replace the battery promptly.
Battery replacement:
Nudge in the direction shown in the illustration and remove the
battery back cover.
Remove the battery (please use a sharp object to pick out the battery)
As shown in the figure, place the "+" pole side with the new battery
facing up.
Close the battery cover and fasten it.
How to use the battery
Battery: Button Battery CR1620
Data synchronization
Settings
Wake up alarm
Software function introduction
