What’s Required?
●
#1 Phillips Screwdriver
●
Cutting tool - such as scissors or diagonal cutter
●
1.5 mm hex wrench
●
2 mm hex wrench
Let’s get started!
Warning: Installation of this kit into a drone should be done by an experienced
person, in adherence with all recommendations and guidelines of the Matrice
manufacturer. Before assembling this kit, ensure the Matrice 100 is not powered,
has the battery removed, and the rotor blades removed. Failure to follow these
instructions can result in injury and/or damage to the Matrice, RedEdge, or Altum.
Attaching DLS 2 mast assembly
1. Locate and remove the DJI mast kit from its packaging.
2. There are three carbon rod sizes. Choose the longest and insert it into the base mount.
3. Secure the base mount with the included M2 screw.
4. Place the top cap on the other side of the carbon rod.
5. Secure the top cap on the rod by screwing the M2 screw.
6. Screw in the base of the mast assembly into the aircraft frame using the provided M2.5
screws and mating cap.
7. Secure the DLS2 mounting disc to the mast using the provided M2.5 x 4mm screws.
8. Mount the DLS2 to the DLS2 mounting disc using the provided M2 x 6mm screws.
9. Ensure the DLS 2 connector is oriented toward the front of the drone.
10. Use zip ties to secure any loose wires
.
PAGE 3
