Thank you for your purchase!
These instructions show how to integrate the MicaSense RedEdge-MX and/or Altum with a DJI
Matrice 100. It covers attaching mounting brackets included in the kit, powering the camera
from the host system, and placement of the Downwelling Light Sensor (DLS 2) unit.
Warning: This kit is not intended for any other RedEdge models other than the
RedEdge-M/MX and Altum. Damage will occur if any other RedEdge model is
connected.
What’s inside?
1.
Battery Eliminator Circuit (Qty 1)
2.
Fixed Mount Plate (Qty 1)
3.
XT30-DF13 Cable (for Altum) (Qty 1)
4.
M 3 X 0.5, 6 mm Screws (Qty 4)
5.
M 3 X 0.5, 5 mm Screws (Qty 4)
6.
M 2 X 0.4, 6 mm Screws (Qty 2)
7.
M 2.5 X 0.45, 4 mm Screws (Qty 2)
8.
M3 internal tooth washer (Qty 4)
9.
M3 Flat washer (Qty 8)
10.
Alcohol Wipe (Qty 1)
11.
Zip Ties (Qty 4)
12.
Double Sided Tape (Qty 5)
13.
DLS2 Mounting Disc (Qty 1)
14.
DLS2 Mast kit (Qty 1)
NOTE: Images shown are not to scale.
PAGE 2
