RedEdge-M & RedEdge-MX Instructions
Attaching the RedEdge-M or RedEdge-MX and the Mount
NOTE
: These instructions assume that the Matrice 100 has a battery bay installed on the
bottom of the aircraft main body. The fixed mount plate attaches to the bottom of the battery
bay.
1. Locate the M3 screws, M3 flat washers, M3 lock washers, and fixed mount plate.
2. Attach the mount to the back of the RedEdge-M or RedEdge-MX.
3. The order of washers is important. Starting from the camera, the assembly order should
be camera > bracket > flat washer > lock washer > M3 x 5mm screw.
4. Next, attach the mount to the Matrice 100 battery cover using the M3 x 6mm screws
and internal tooth washers. Hand tighten until snug, then using a tool turn an additional
¼ turn.
5. When attached, the camera will be tilted forward slightly to compensate for the tilt of
the aircraft while flying.
PAGE 5
