PAGE 3
Attaching the RedEdge-M to the Inspire 1
1. Ensure that the Inspire 1 legs are in landing mode (not in travel mode).
2. Attach the assembled Quick Mount (with connected RedEdge-M) to the Inspire 1 using the DJI lock mechanism
on the Inspire 1.
3. Angle the camera so that, while flying forward, it will point nadir (straight down). The forward-tilt angle can vary
by aircraft, but it is typically 8º to 12º.
Once assembled, the Quick Mount can quickly and easily be installed or removed from the
Inspire 1. Power is provided by the Inspire 1 via the Quick Mount.
QuickMount on Inspire 1
Assembling and attaching the DLS/GPS top mount
1. Line up the three holes on the DLS base plate, the top mount riser, the GPS base plate, and the top mount as
shown in the image below.
2. Place the provided M3 x 25 mm screws through all, and screw them into the top mount.
3. To promote adhesion, use the included alcohol wipe to clean all surfaces where VHB tape will be applied.
4. Apply the VHB tape to the GPS base plate.
5. Thread the GPS cable between two of the legs of the top mount riser. Center the GPS over the GPS base plate,
and firmly press together.
6. Make sure the arrows on the DLS and GPS are both pointing forward (toward direction of travel). Secure the
DLS to the mounting plate as shown using the two M2 x 6 mm screws, washers, and nuts.
