PAGE 4
Warning: Failure to properly secure loose wires may lead to interference with the aircraft
propellers. This may damage the Inspire 1, RedEdge-M, or both.
7. Plug the GPS wires into the back of the DLS.
8. Using a hex key, remove the two hex screws at the top-front of the Inspire 1
9. Attach the top mount to the drone using the M2.5 x 16 mm screws (do not reuse the hex screws).
10. Attach one of the DLS Quick Mount cables from the DLS Quick Connect board to the RedEdge-M and
the other from the Quick Connect board to the DLS.
11. Using the included zip ties, secure the wire to the aircraft frame as necessary.
12. Use VHB tape to secure the DLS Quick Connect board to the aircraft.
13. Using scissors or similar, trim the zip ties.
