Showing DLS2 mast mounted on Inspire 2 with DLS 2 connector facing forward
Warning: Failure to properly secure loose wires may lead to interference with the
aircraft propellers. This may damage the Inspire, RedEdge-MX/Altum, or both.
RedEdge-MX Instructions
Attaching the RedEdge-MX and the Mount
1. Locate the two M3 x 6 mm socket head cap screws, M3 lock washers, and Quick Mount
Gen. 2 Adapter.
2. Using the counterbore screw holes, attach the mount to the back of the RedEdge-MX.
Make sure the mount 8-pin camera port is located on the same side as the camera
“PWR/TRG” port.
Rev 01 - August 2019
PAGE 4
