Altum Instructions
Attaching the Altum and the Mount
1. Locate the two M3 x 8 mm socket head cap screws, M3 lock washers, and Quick Mount
Gen 2 Adapter.
2. Using the counterbore screw holes, attach the mount to the back of the Altum. Make
sure the 8-pin camera port found on the Quick Mount is located on the same side as
the camera “HOST” port.
3. Connect the provided Altum Gen. 2 Quick Mount cable to the “HOST” port found on
the Altum camera and the Power/Trigger and Communication ports found on the Quick
Mount.
MicaSense Altum connected to Quick Mount Gen. 2
Rev 01 - August 2019
PAGE 7
