Attaching the Altum and DLS 2 to the Inspire
Once assembled, the Quick Mount Gen. 2 can quickly and easily be installed or removed from
the Inspire. Power is provided by the Inspire via the Quick Mount Gen 2.
1. Attach the assembled Quick Mount Gen. 2 (with connected Altum) to the Inspire using
the DJI lock mechanism on the Inspire.
2. Plug the DLS 2 cable from the DLS 2 port to the Quick Mount Gen. 2 “6-pin DLS” port.
3. When attached, the camera will be tilted forward slightly to compensate for the tilt of
the aircraft while flying.
Warning: Failure to properly secure loose wires may lead to interference with the
aircraft propellers. This may damage the Inspire, RedEdge-MX/Altum, or both.
Rev 01 - August 2019
PAGE 8
