Quick Mount Gen 2 Adapter attached to RedEdge-MX
Attaching the RedEdge-MX and DLS 2 to the Matrice
Once assembled, the Quick Mount Gen. 2 can quickly and easily be installed or removed from
the Matrice. Power is provided by the Matrice via the Quick Mount Gen 2.
1. Attach the assembled Quick Mount Gen. 2 (with connected RedEdge-MX) to the drone
using the DJI lock mechanism on the gimbal connector.
2. Use the provided 6-pin 60cm cable to connect the DLS2 and the RedEdge-MX. Plug the
DLS 2 cable from the DLS 2 port to the Quick Mount Gen. 2 “6-pin DLS” port.
3. When attached, the camera will be tilted forward slightly to compensate for the tilt of
the aircraft while flying.
Warning: Failure to properly secure loose wires may lead to interference with the
aircraft propellers. This may damage the drone, RedEdge-MX/Altum, or both.
Altum Instructions
Rev 01 - July 2020
PAGE 6
