9
9. CYLINDRICAL SWEEPING BRUSHES - ADJUSTING THE HEIGHT
The height of the cylindrical brushes is dependent on the brush wear. To adjust the
height rotate the knob which is located on the right side of the cylindrical brush assembly.
Turn the knob counterclockwise to lower the brushes and clockwise to lift the brushes.
Note:
The brushes should be slightly touching the floor.
8. ADJUSTING THE SQUEEGEE HEIGHT
The height from the floor to the squeegee should be adjusted based on the blade’s wear.
Rotate the knob (2) clockwise (tighten) to lift the squeegee and counterclockwise (loosen)
to lower it.
Note:
Adjust the right and left knobs the same amount; the squeegee should be
positioned parallel to the floor.
MACHINE PREPARATION
5.
Place the brushes under the base. Line up the three lugs with the holes in the brush
plate. Insert the brushes into the plate and turn each brush so the lugs are pushed
toward their retaining springs, until clamped in place. The figure shows the direction
of rotation for the coupling of the right brush. The left brush has to be rotated
inversely.
10. ROTARY BRUSH ASSEMBLY
1.
Connect the battery connector.
2.
Turn the key to the
ON
position.
3.
Lift the brush base with the brush lever.
4.
Return the key to the
OFF
position.
Do not attempt to attach the brushes with the
power on, injury to the hands may result!
Summary of Contents for ScrubMaster 30R
Page 24: ...NOTES 23...
