34
Anschlussvariante 5:
Lüftungsgerät + Raumluftste
Hygrostat HY 5
. Siehe auch Verdrahtungs-
plan im Anhang
Anschluss eines Hygrostaten mit potential-
freiem Kontakt zur bedarfsgerechten
Feuchteabfuhr, z. B. Maico Hygrostat HY 5.
Wenn bei Raumfeuchte der potentialfreie
Kontakt im Hygrostat schließt (wenn der
eingestellte Feuchtewert überschritten wird),
wird das Lüftungsgerät unabhängig von der
eingestellten Lüftungsstufe auf LS3 geschaltet.
Wenn die Raumfeuchte abgebaut ist (Kontakt
im Hygrostat öffnet) schaltet das Lüftungs-
gerät wieder auf die zuvor eingestellte
Lüftungsstufe zurück.
A
Elektro-Anschlusskasten WR 600
A2
Steuerplatine:
Jumper 8 gebrückt = Werkseinstellung.
Jumper 10 (CO2) offen
B
Raumluftsteuerung RLS D1 WR
B1
Raumluftsteuerung RLS 1 WR
(alternativ zu RLS D1 WR)
r.F.
Hygrostat HY 5 oder HY5I,
siehe Zubehör
Wenn Sie Lüftungsstufe 3 von Hand in Stufe
2 oder 1 zurückschalten, ist die Automatik-
funktion des Hygrostaten vorübergehend
deaktiviert. Diese ist dann wieder aktiv
geschaltet, wenn der eingestellte Sollwert des
Hygrostaten einmal unterschritten wird.
● Schließen Sie den Hygrostaten an
Klemme
„CO2" an.
● Jumper 10 auf der Steuerplatine A2
muss offen sein.
● Stellen Sie den Schaltpunkt am
Hygrostaten manuell ein.
● Schließen Sie nie einen Hygro-
staten und CO
2
-/VOC-Sensor
gemeinsam an.
W1
Anschlusskabel 230 VAC
W2
Geschirmte Steuerleitung (bauseitig)
für Raumluftsteuerung RLS D1 WR
W2´
Steuerleitung (bauseitig) für Raumluft-
steuerung RLS 1 WR
W4
Anschlusskabel für externen Hygro-
staten (bauseitig). Außendurchmesser
3,2 ... 6,5 mm, z. B. LIYY 2 x 0,5 mm².
Anschluss auf Steuerplatine A2 an
Klemmen „CO2“, siehe Abbildung.
i
Summary of Contents for aeronom WR 600
