MICOM SWING SW & SWSP
Installation Manual
Page
26
8.2 Internal Basic Connections
Connection from the transformer to the feed supply.
The connection from the transformer to the supply should be done with an 8-wire cable. This
connection takes place in the factory and the technician should only have to do it in the event of a
breakdown or when having to replace components (see the following figure for more details).
Connection from the supply to the control unit.
The connection from the supply source to the control unit will be done with a 4-wire cable. This
connection will be done in the factory and the technician should only have to do it in the event of a
breakdown or when having to replace components (see the following figure for more details).
Connection from the motor to the Control Unit
The connection from the motor is done with two cables: one of 2 wires (feed) and the other 4 wires
(position coder). This connection is done in the factory and the technician should only have to do it in
the event of a breakdown or when having to replace components (see the following
figure for more
details).
Connection:
Motor / Control Unit
Connection:
Transformer / Power Supply
Connection:
Power Supply / Control Unit
