MICOM SWING SW & SWSP
Installation Manual
Page
43
2.
Press and hold “ENTER PROG.”
1.
Press and hold “+ RESET”
3. If done correctly, 3 red lines will blink on the
display. Press and hold both buttons until sound
signal disappear (5 seconds approx.).
12.2.5 RESET of the programming
The control unit retains programming parameters in its memory and also other important details such
as door operation setting
from the learning process as well as braking adjustments etc…
This data can be reset to factory default setting.
The RESET of the Control Unit can be done in two ways:
First (recommended)
●
Remove the power supply from the Control Unit (if so, also the battery).
●
Press the “RESET” button and keep it pressed, then re-insert the power supply to the Control
Unit.
●
Wait 5 seconds until the Control Unit stops beeping.
●
Stop pr
essing the “RESET” button.
Second
●
Press the “+ RESET” button and then “ENTER PROG.” and maintain them both pressed for
5 seconds.