Micrel Confidential
4
June 2006
KSZ8862-16 MQL Demo Quick Start Guide
Setting Up the IP Address for the PC
This section describes how to change the IP address for your PC in order to run the TCP_GUI
demo software. The default IP address is 192.168.1.1. in the Demo Board. For the PC, the user
can set the IP address to 192.168.1.X (X: don’t care) and the Subnet mask to 255.255.255.0 (see
the Figure 4).
To change the IP address, proceed as follows:
Go to: Start -> Settings -> Network and Dial-up Connections -> Local Area Connection.
Right click on Local Area Connection and click on Properties.
Click on “Internet Protocol (TCP/IP)” and then click properties, change the fields so that
they are the same as in Figure 4 and select OK.
Click OK again to get out of Local Area Connection properties and click Close to get out
of this window.
Figure 4: Setting Up the IP Address for the PC
You can use the
PING
command from your PC to test whether the KSZ8862-16MQL demo
board is accessible over the network. To open the Command Prompt, proceed as follows:
Go to: Start -> Programs -> Accessories -> Command Prompt and click on Command
Prompt.
Type “ping 192.168.1.1” and “Enter” as shown in Figure 5.
