MICRO AIR
®
MX3510
CLEAN AIR SYSTEMS
4
MX3510
MICRO AIR
®
CLEAN AIR SYSTEMS
5
UNITS WITH HEPA OR CHARCOAL OPTIONS FOR
MX3510
1.
On units with optional HEPA or charcoal filters, an adjustable filter
track kit is used to complete the seal of these filters to the filter
stop (See
FIG. 4
&
5
). If the unit was ordered with either a HEPA
or charcoal filter, this adjustable filter track kit was included with
the unit. If a HEPA or charcoal filter is ordered as an after-market
item, the adjustable filer track kit should be ordered as well. Order
Part No. 38036-01.
Each filter track kit is supplied with:
j
1pc. Filter track
k
2pc. Supports
l
1pc. Handle
m
4pc. Retaining brackets
n
1pc. Door stop bracket
o
3pc. Horizontal support
p
16pc. #8-32 self tapping hex screws.
HEPA OR CHARCOAL AS SECOND MAIN FILTER
1. Place supports
k
in cabinet at a dimension of 13 1⁄4” and
secure with self tapping screw.
2. Place track
j
in cabinet so it rests upon supports and 1⁄2”
diameter pin is located behind brackets on supports.
3. Place handle
l
on supports so that it rests in notches.
4. Lock 1⁄2” diameter rods on handle and track in place with
brackets
m
and self tapping screws.
5. Place handle stop bracket
n
at a dimension of 15 1⁄2” and
secure with self tapping screws. This is to keep handle
from rotating past 90° and allowing filter to loosen.
6. Place horizontal supports
o
in 2 places. One piece at
a dimension of 5” on bottom of cabinet and one piece at
a dimension of 10” on rear of cabinet with self tapping
screws.
13”
10”
5”
5
3
1
2
TYP. 2 PLCS.
4
TYP. 4 PLCS.
6
6
RCM
FIG. 4