Technical Data
2.7
CF Lens and Protective Window
If the CF lens is used, the
transmission has to be set to
0.78
[SF15/ 2W/ HS].
The optional CF lens allows the measurement of very small
objects. The minimum spot size depends on the used sensor. The
distance is always measured from the front edge of the CF lens
holder or laminar air purge collar. The installation on the sensor
will be done by turning the CF lens until end stop. To combine it with the HS model please use the
version with external thread M12x1.
Versions Overview:
TM-CF-CS
CF lens for installation on sensor [SF15/ 2W/ HS]
TM-CFH-CS
CF lens for installation on sensor [2WM-2]
TM-CFAG-CS CF lens with external thread for installation in massive housing [SF15/ 2W/ HS]
TM-CFHAG-CS CF lens with external thread for installation in massive housing [2WM-2]
For protection of the sensor optics a protective window is available. The mechanical dimensions are equal
to the CF lens. It is available in the following versions:
TM-PW-CS
Protective window for installation on sensor [SF15/ 2W/ HS]
TM-PWH-CS Protective window for installation on sensor [2WM-2]
TM-PWAG-CS Protective window with external thread for installation in massive housing [SF15/ 2W/ HS]
TM-PWHAG-CS Protective window with external thread for installation in massive housing [2WM-2]
If the protective window is used, the transmission has to be set to
0.83
[SF15/ 2W/ HS] or
0.93
[2WM-2].
thermoMETER CSmicro
16
Summary of Contents for 2WM-2
Page 1: ...Infrared Sensor Operators Manual thermoMETER CSmicro SF15 SF02 2W 2WM 2 HS...
Page 2: ......
Page 42: ...thermoMETER CSmicro 40...
Page 43: ...thermoMETER CSmicro 41...