Page 52
Operation
induSENSOR DTD / MSC7xxx
5.3.4
Adjustment
LED D2 = green
At the menu
Settings > Adjustment
, you can use either a two-point adjustment or a Zero-point adjust-
ment. In this menu, the controller can also be reset to the factory settings.
Two-point adjustment Here you can set any 2 points within the measuring range and the corresponding
signal values.
Factory settings
The controller can be reset to the parameters stored by default
Zero-point adjustment This is a special case of a two-point adjustment and provides the best performance
for the measuring system. The first of the two points is the electrical zero point at
which a differential sensor shows the highest stability on principle.
X
1
V
2
V
1
X
2
V
2
V
0
X
2
X
0
Fig. 54 Graphic Two-point adjustment
Fig. 55 Graphic Zero-point adjustment
