Page 126
Merging
thermoIMAGER TIM Connect
Here you make several modifications on your imager. You can change the name, the picture of the camera
and the position of the picture. Under
Config target imager
you can define the exact position of the
target. So here you define where the picture should start. Repeat the same with the second instance
(In-
stance 2)
. You can arrange the picture side by side or on top of each other. The coordinates depends on
the camera you’re using. For example if you use two cameras with an optical resolution of 640 x 480 and the
picture should be side by side you have to use following values for the whole picture:
e.g. TIM 640
Position in target X Position in target Y
Instance 1
0
0
Instance 2
639
0
In this example the picture of the camera of Instance 1 is on the left side and the picture of the camera of
Instance 2 begins lightly overlapping next to it.
