Adjusting Belt Tracking
While the sander is operating, use a small screw-
driver to turn the R-L adjuster shown in Figure D
until the belt tracks down the center of the drive
rollers and platen without striking the case.
Installing the Vacuum Pick-Up
Simply push the small end of the vacuum hose
onto the fitting at the lower rear of the sander.
Connect the large end to your standard 1-1/4”
shop vacuum hose with the rubber adapter
supplied with the sander.
Sanding Flat Surfaces
Move the platen control knob to the
position shown in Figure E to sand
flat surfaces.
Sanding Curved Surfaces
Move the platen control knob to the
position shown in Figure F to sand
curved surfaces.
Sanding Small Parts
Small parts may be sanded by
mounting the sander upside
down on the workbench.
Mounting brackets and screws
are included for this mounting;
follow the arrangement shown
in Figures G and H. Small
parts are sanded by holding
them against the fence.
Lubrication and Maintenance
No additional lubrication is required during routine use. If the sander is disassembled for any reason,
a small amount of an appropriate lubricant should be applied to bearing surfaces.
Avoid a large build-up of caked-on sawdust; it will block the cooling passages built-in to the sander and
reduce its life. A thorough “blow-out” after each use will keep the sander from getting clogged.
Replacement Parts
This sander is designed to give you years of trouble-free service. However, should a replacement part
be required, locate it on the Parts Schematic and identify it by its numeric designation. Our service
technicians are available to help provide you with the technical assistance and parts you need to keep
your sander in fine running condition.
If you require assistance, call Micro-Mark Technical Support from 1 pm to 5 pm E.T. at 908-464-1094.
Fig. D
Fig. F
Fig. E
Fig. H
Fig. G
This product is guaranteed to be free of manufacturing defects for a period of 90 days from date of shipment. It will
be repaired or replaced (at our option) free of charge if returned post-paid within that time period. Please return to
Micro-Mark Product Service Department
and include a note explaining the problem. Consequential
damages resulting from the use of this product are not covered by any guarantee and are the sole responsibility of
the purchaser. Any problem resulting from abuse or misuse of the product will not be covered under this guarantee.
