- 13
does not blow dust and items around. Insert with the tabs at 12 and 6
o’clock and rotate clockwise to install. Removal is reverse direction.
Note:
There is a suction-break button near the exhaust port. This can be
pressed when the wand picks up something by mistake that is not
intended to be suctioned. Hold it down, momentarily until the
unintended item drops off of the wand head. Sometimes, depending on
what is stuck in the wand may not fall off in which case you will need
shut off the motor and / or remove it by hand with care.
Application: Wet Cleaning
During wet clean-up, special care must be taken by the user to avoid
electric shock, motor damage and spillage of what is being suctioned.
1-
Make sure that the electric cord is in good condition and the
outlet to be used is in good operation condition and is properly
grounded.
2-
Do not place the unit into standing water greater than 1 inch.
3-
User must remove the filter from within the tank and re-attach
the head onto the tank. The filter is only used for dry clean-up.
4-
The used should not be standing in the liquid that is to be
suctioned.
Summary of Contents for 90533
Page 3: ... 2 Parts Identification Fig 1 ...
Page 5: ... 4 Production Standard Safety Notice ...
Page 19: ... 18 ...