Micro Matic MDD23W Series, Installation, Use & Maintenance Manual

  www.micromatic.com   •   1 (866) 327-4159

Installation, Use & Maintenance

10

Pro-Line Wine

How To See The Set Point

1.  Push and immediately release the 

key, the set point will be displayed.

2.   Push and immediately release the 

 key or wait about five (5) seconds to return to 

normal display.

How To Change The Set Point

1.  To change the set point number, push the 

 key for more than two (2) seconds.

2.  The number of the set point will be displayed and the “ ” or “ ” LED will blink.

3.  To change the set number push the arrow up or down keys within ten (10) seconds.

4.  To hold the new set point number push the 

 key again or wait ten (10) seconds.

How To Change A Parameter Number

1.   Enter the Programming mode by pressing the 

  keys for three (3) seconds, the 

“ ” or “ ” LED will blink.

2.  Select the required parameter. Press the 

 key to display the number.

3.  Use the up or down arrow keys to change the number.

4.  Press 

to store the new number and move to the following parameter.

To exit: Press 

 or wait fifteen (15) seconds without pressing a key.

 NOTE:  The set number is stored even when the procedure is exited by waiting for the  

time-out to expire.

How To Enter The Hidden Menu

1.   Enter the programming mode by pressing the 

 keys for three (3) seconds, the 

“ ” or “ ” LED will blink.

2.   Release the keys, then again push the 

 keys for more than seven (7) seconds. 

The L2 label will be displayed immediately followed by the Hy parameter.

NOW YOU ARE IN THE HIDDEN MENU

3.  Select the required parameter.

4.  Press the 

 key to display its number.

5.  Use the up or down arrows to change its number.

6.  Press the 

 key store the new number and move to the following parameter.

To Exit: Press the 

 or wait 15 seconds without pressing a key.

NOTE 1:  If no parameter is present in L1, after three (3) seconds the nP message is 

displayed. Keep the keys pushed until the L2 message is displayed.

NOTE 2:  The set number is stored even when the procedure is exited by waiting for the 

time-out to expire.

NOTE:

   Any change in these parameters will effect unit performance and void warranty.