www.micromatic.com • 1 (866) 327-4159
Installation, Use & Maintenance
13
Pro-Line Wine
Data Plate
The data plate is located inside the unit, near the top front left corner. Under no circumstances
should the data plate be removed from the unit. The data plate is essential to identify the
particular features of the unit and is of great benefit to installers, operators and maintenance
personnel. It is recommended that, in the event the data plate is removed, you copy down the
essential information in this manual for reference before installation.
If service is required call 1-800-544-0400
Service agent will require the data plate information.
Electrical Connections
Refer to the amperage data in this manual or on data plate and your local code or the National
Electrical Code to be sure unit is connected to the proper power source. Verify correct incoming
voltage according to the Data Plate information.
A protected circuit of the correct voltage and amperage must be run for connection of the supply
cord. Unit must be grounded and connected in accordance with NEC Article 422 Appliances.
DANGER: Power must be turned off and disconnected from the power source whenever
performing maintenance, repair or cleaning the condensing unit. If unit is still running when
power is off, disconnect power at the circuit breaker before unplugging the unit.
WARNING: Unit and compressor warranties are void if failure is due to improper electrical
installation.
