USER MANUAL
m crob t
AS-1289
Ba-AS1289-PA1
(reparerad)
Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. PA1
– 2014 feb 17
15 of 46
Initial IP setup
The default Ip settings from the factory is 192.168.0.236. The net mask is 255.255.255.0,
gateway and DNS is 192.168.0.1.
To be able to contact the AS-1289 via the network you must configure the units to fit into
your home network. You can check your network configuration from your PC.
On the start menu select Run. In the Run dialog box enter cmd.
You will get a DOS-window.
At the DOS-promt enter ipconfig.
Then you will get the needed information:
Your PC IP address in this example is 192.168.0.101 this means that the IP of the AS-1289
must have IP:s in the area 192.168.0.2 to 192.168.0.255.
