USER MANUAL
m crob t
RRC-1258 MKII
Ba1258B_RemoteRig_MkIIs-A30
Microbit 2.0 AB 2010. All rights reserved
a
User manual
Rev. A30
– 2014 Jan 21
81 of 228
The 2.4 GHz Wifi Interface is compliant to 802.11b/g and single stream 802.11n and supports
WPA2- (AES), WEP (64 and 128 bit) modes of security in infrastructure mode and also TKIP in
SPI mode.
There is no limitations compared to Ethernet, all settings that are used when they are
connected to Ethernet can be used.
The RRC automatically switch between WiFi or Ethernet. IF Ethernet is connected, Ethernet
will be used.
Connecting to a Wifi network
The easiest way to setup the WiFi connection is to do it via the Microbit Setup manager. If you
know the parameters it can be done from the web interface also, but you cannot scan WiFi
Networks that way so we focus on using the Setup manager.
Do not forget to connect 12V power to the RRC, the setup works when the unit is powered
from USB but you can not scan for WiFi networks until you connect 12V.
The RRC can store settings for up to 8 different WiFi networks. The RRC will automatically
connect to the strongest network from the list. You can not force the RRC to connect to a
specific network, if you must do that, you have to remove the unwanted network from the
list.
-
Disconnect the Ethernet cable if it’s connected, Connect 12V to the RRC, and connect the
USB cable from your PC to the RRC. Start the Microbit setup manager
-
Select the WiFi tab
