MicroBoards Technology Copywriter Flash Duplicator, User Manual

10

Utility 

The Utility function is available for erasing inserted cards and updating the Duplicator firmware. 

Measure Speed 

The Measure Speed function can be turned on to measure the exact speed of the flash read 
and write. 

Media Check 

This function checks the media quality, and can be set to 3 different levels: Normal 100%, 
Strict 100%, and Setup Range.  Regardless of the setting, if the check detects a read or write 
error, the LED for that flash card will show red. 
Normal 100% will use bit 0 to perform a write and read to examine the flash quality. 
Strict 100% will use bits 0 and 1 to perform a write and read to examine the flash quality. 
Setup Range allows you to specify the percentage of the flash media that gets checked.  The 
range can be set from 1% to 100%. 

Quick Erase 

This will perform a quick erase on any card inserted into any port, 

including the reader port.

Do not run the erase function with your master card in the duplicator. 

Full Erase 

This will perform a full erase on any card inserted into any port, 

including the reader port.

Do not run the erase function with your master card in the duplicator. 

System Update 

This will update the system firmware from the card in the Reader port.  Do not attempt to 
perform an update unless directed to by Technical Support. 
 
 

Setup Menu Flowchart 

6.  Setup

OK

1.  Start-up Menu

3.  Button Beep

4.  Asyn Hold Time

5.  Ignore Size

6.  Asynchronous

Turn the Button Beep ON or OFF.

This setting determines how long the 
system will wait before continuing or 
exiting an Asynchronous duplication job.

Sets the tolerance percentage of source 
and target flash capacity difference.

This setting specifies which of the 6 Main 
Menu items is the default that shows on 
start-up.

▼

▼

▼

▼

OK

OK

OK

OK

OK

This setting can be set to 

Only Data Area

 and 

Whole 

Area

.

2.  Copy Area

▼

OK

This setting specifies the 
language displayed on the 
interface.

7.  Language

▼

OK

This must be set to ON for 
Asynchronous duplication.