MicroBoards Technology GX-2, User Manual

MICROBOARDS TECHNOLOGY, LLC                                                                                           GX-2 DISC PUBLISHER 

7 

Installing Ink Cartridges 

Supported Ink Cartridges 

The GX-2 Disc Publisher uses a single color ink cartridge.  The part number for this cartridge is GX-
300HC.  If other cartridges are installed, the GX-2 Disc Publisher will not function.  These cartridges 
are available from any Microboards reseller. 

Refill kits or non-Microboards ink cartridges are not recommended for use in the GX-2 Disc 
Publisher system.  Use of these types of cartridges will cause the printer to fail.  Use of these 
types of cartridges will void the warranty. 

Loading / Replacing Ink Cartridges 

Cartridges can be changed while the GX-2 Disc Publisher is on, but it should never be turned on 
without an ink cartridge in place. 

The GX-2 Disc Publisher system ships with one 

Microboards GX-300HC

 color ink cartridge. 

•

Remove the front cover.  The print cartridge cradle will be on the right side of the GX-2 Disc 
Publisher, as shown below.     

•

Tilt the old cartridge forward to release the cartridge from the cradle, as shown in the inset 
below. 

•

Lift the old cartridge out of the cradle. 

•

  Remove the new print cartridge from its packaging and carefully remove the plastic tape.   

Hold the print cartridge so that the copper strip is at the bottom. 

•

With the front of the new ink cartridge tilted down, slide the cartridge into the cradle. 

•

Tilt the front of the cartridge back up to lock the ink cartridge in place. 

•

Replace the front cover. 

The Microboards GX-300HC Ink Cartridge must be used or the printer will not function.