Microboards Technology, LLC
16
CD+G Support
This feature allows CD+G content to be copied from master disc to blank CDs. The default is
OFF
.
Please note that the Mix Audio Tracks function cannot be performed with the CD+G Support
setting
ON
.
Remember, you must use the Shutdown menu or manually
Save the settings under the Utilities menu if you want any
changes you have made to remain after the Duplicator is shut
down!
The Utilities Menu
A description of the options in the Utilities menu follows. Use the
▼▲
buttons to scroll through
the menu, pressing the
ENT
button when the display shows the function you want to perform.
Disc Info
The Disc Info function will display the information regarding the blank recordable media you have
loaded in the recorders. The media format, capacity, manufacture ID, and certified writing speed
of the media will be displayed.
Information regarding any master disc loaded into the reader drive will also be displayed.
Load your media into the drives before pressing
ENT
when the display shows
Disc Info
. Each
drive will be checked to see if media is present. If all drives are not filled, you will be shown the
number of discs detected and be prompted to press the
ENT
again.
Use the
▼▲
buttons to scroll through the drives in which media has been detected.
Prescan
The Prescan function is used to verify the readability of the master disc by scanning for bad
sectors on the master. Performing the Prescan on your masters before duplicating will help
reduce the number of duplication failures caused by a master that contains uncorrectable errors.
You should load your master into the source drive prior to pressing the
ENT
button when the
display shows
Prescan
. Your master will be scanned, with the results being displayed when the
analysis is complete.
If the results show that the master disc
Failed
, you should not attempt to use that master as a
source disc.
System Info
The System Info menu selection displays the model and firmware versions of the installed
controller. Use the
▼▲
buttons to scroll through the system information.
Device Info
The Device Info menu selection displays the model and firmware versions of the drives installed
in your QD-DVD Duplicator. Use the
▼▲
buttons to scroll through the device information.
Load Default
This option restores all Setup and Advanced Setup options to the default settings, as well as the
default Burn Speed and the selected Source drive settings.
Update Firmware
Use the Update Firmware menu option to update the programming on your Duplicator. To update
the firmware, you will need to have the correct firmware file burned to a CD.
Please note that “drag-and-drop” burn methods such as the Windows XP burn utility generally will
not be recognized as valid as the disc format they create is not recognizable by the duplicator.
