Protouch2 GUI User Manual
2016 Microchip Technology Inc
Page 12
Collision: LED will monitor the Collision in Link
Activity: LED will monitor the Activity in Link
Auto-Negotiation Fault: LED will monitor the Auto-
Negotiation Fault in Link
Serial Mode: LED will monitor the Serial Stream
Force LED OFF: This will De-assert the LED
Force LED ON: This will assert the LED
LED1Behavior
The hex value of LED Link/pulse behaviour
"LED1Behavior":"0x10"
LED2Behavior
The hex value of LED Link/pulse behaviour
"LED2Behavior":"0x15"
GPIOEnable
Hex values of GPIO groups (0x0FFF)
Value 1 - Disable GPIO
Value 0 - Enable GPIO
"GPIOEnable":"fdf"
GPIOBuffer
Hex values of GPIO groups (0x0FFF)
Value 0 - Open-drain
Value 1 - push/pull
"GPIOBuffer":"20"
GPIODirection
Hex values of GPIO groups (0x0FFF)
Value 0 - Output
Value 1 - input
"GPIODirection":"20”
GPIOData
Hex values of GPIO groups (0x0FFF)
Value 0 – low
Value 1 – high
"GPIOData":"20"
GPIOWake
Hex values of GPIO groups (0x0FFF)
Value 0 = The GPIO cannot wakeup the device.
Value 1 = The GPIO can trigger a wakeup event.
"GPIOWake":"158"
GPIOWakePolarity
Hex values of GPIO groups (0x0FFF)
Value 0 = Wakeup/interrupt is triggered when
GPIO is driven low
Value 1 = Wakeup/interrupt is triggered when
GPIO is driven high
"GPIOWakePolarity":"146"
eepromconfigflag0
Configuration Flags 0. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7D18007”
Eepromconfigflag1
Configuration Flags 1. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7E18007”
Eepromconfigflag2
Configuration Flags 2. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7218007”
Eepromconfigflag3
Configuration Flags 3. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7A18007”
Eepromconfigflag4
Configuration Flags 4. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7B18007”
Eepromconfigflag5
Configuration Flags 5. It’s a 32 bit hex value.
“eepromconfigflag0”:”
7318007”
